StackState version 4.2 (EOL)
🚀
Setup
👤
Use
Install with production configuration
This page describes StackState version 4.2.
The StackState 4.2 version range is End of Life (EOL) and no longer supported. We encourage customers still running the 4.2 version range to upgrade to a more recent release.
StackState prefers Kubernetes!
In the future we will move away from Linux support. Read how to migrate from the Linux install of StackState to the Kubernetes install.
Requirements
Before starting the installation, ensure your system(s) meet StackState's production deployment installation requirements.
Two-node deployment architecture
The StackState production environment requires two nodes a StackGraph and a StackState node.
Configure StackState to run in the two-node setup requires the following steps:
Preparing the StackGraph node
- 1.Install the package using the instruction for Installing StackState, using
PRODUCTION-STACKGRAPHas SETUP configuration parameter. - 2.
Preparing the StackState node
To prepare an additional node for running a StackState component, follow these steps:
- 1.Install the package using the instruction for Installing StackState, using
PRODUCTION-STACKSTATEas SETUP configuration parameter.
Further Configuring StackState
After you have installed StackState, refer to the following pages for configuration instructions:
Starting and Stopping
Note that the StackGraph node always needs to be running before starting StackState
Starting and Stopping StackGraph
On the StackGraph node, the following commands will start/stop StackGraph:
sudo systemctl start stackgraph.servicesudo systemctl stop stackgraph.serviceStarting and Stopping StackState
On the StackState node, the following commands will start/stop StackState:
sudo systemctl start stackstate.servicesudo systemctl stop stackstate.serviceLast modified 1mo ago